When locked, the value will continue to flash and the Value Wheel can be used to adjust the value at any time until the Parameter Button is used to select a different parameter.Īny parameter can be set back to its default value by pressing and holding the Value Wheel for 2 seconds or until the red LED flashes once. When the desired parameter is flashing, press and hold the parameter button for 2 seconds. This is useful when you would like to audition and compare the sound of various values without needing to press the Parameter button each time you make a change. You can also ‘lock’ a parameter to the Value Wheel, meaning it will remain active, flashing and will never time out. However, pressing the Auto/Manual ( A / M ) button can be used as a shortcut to the Preset Parameter. For example, if you recently made a change to the Subdivision of your preset, the next press of the Parameter Button will begin at the Subdivision parameter, allowing you to again change Subdivision without navigating through various other Parameters. Therefore, adjusting the Preset number will load parameter values saved to that preset.Īny time a parameter value has been changed and confirmed by clicking IN on the Value Wheel, that parameter becomes first in the list when the Parameter Button is pressed again later. All other metronome parameters immediately save to the active Preset when adjusted. ![]() Switching Presets is done by adjusting the Preset Number Value. Some parameters, such as Preset Display Color, Beat Flash & Voice use shared areas of the display and will be hidden unless active by use of the Parameter Button. Only the decimal point of Tempo will flash to show it is ready to be adjusted. Tempo, however, is the default parameter and can be adjusted any time another parameter is NOT flashing. When you are done editing a parameter, you can either click IN on the Value Wheel or let the blinking parameter time-out. Simply press the Parameter Button until the desired parameter flashes and then turn the Value Wheel to reach the value you would like. In general, all parameters of the metronome can be easily adjusted by using a combination of the Parameter Button and the Value Wheel. Tempo Map ( Not selectable but configured in Peterson Connect ). ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |